ESDA6V1BC6 TRANSIL QUAD SUPPR ESD SOT STMicroelectronics datasheet pdf data sheet FREE from Datasheet (data sheet) search. ESDA6VBC6 STMicroelectronics ESD Suppressors / TVS Diodes Quad Bidirect Array datasheet, inventory & pricing. ESDA6V1-BC6 datasheet,Page:1, ® ESDA6V1BC6 QUAD BIDIRECTIONAL TRANSIL™ SUPPRESSOR FOR ESD PROTECTION ASD™ MAIN APPLICATIONS.
|Published (Last):||24 November 2004|
|PDF File Size:||12.11 Mb|
|ePub File Size:||1.34 Mb|
|Price:||Free* [*Free Regsitration Required]|
Bcc6 A8 shows that in such a condition, i. Application Specific Discretes A. Digital crosstalk measurements configuration Figure A7 shows the measurement circuit used to quantify the crosstalk effect in a classical digital application. Specifications mentioned in this publication are subject to change without notice.
ESDA6V1-BC6 Datasheet(PDF) – STMicroelectronics
esds6v1 A3 the high efficiency of the ESD protection: By taking into account the following hypothesis: It is also important to note that in this approximation the parasitic inductance effect was not taken into account.
This phenomenon has to be taken into account when the drivers impose fast digital data or high frequency analog signals in the disturbing line.
Remaining voltage during ESD surge a: The clamping voltage is given by the following formula: The perturbed line cb6 be more affected if it works with low voltage signal or high load impedance few k? ESD protection is achieved by clamping the unwanted overvoltage. Peak power dissipation versus initial junction temperature. Analog crosstalk measurements 50? Capacitance versus reverse applied voltage typical values.
PJEC3V3M1FN2 – Bidirectional ESD protection of one line
Peak forward voltage drop versus peak forward current typical values. This publication supersedes and replaces all information previously supplied. The measurements performed with falling edges give an impact within the same range. STMicroelectronics products are not authorized for use as critical components in esa6v1 support devices or systems without express written approval of STMicroelectronics.
However, STMicroelectronics assumes no responsibility for the consequences of use of such information nor for any infringement of patents or other rights of third parties which may result from its use.
This part of the VG1 signal represents the effect of the crosstalk phenomenon of the line 1 on the line 2. For these kind of disturbances it clamps close to ground voltage as shown in Bd6.
No data disturbance was noted on the concerned line. Relative variation of leakage current versus junction temperature typical values. Typical analog crosstalk measurements Analog crosstalk dB 0 1 10 frequency MHz 1, Figure A5 gives the measurement circuit for the analog crosstalk application. esea6v1
In usual frequency range of analog signals up to MHz the effect on disturbed line is less than dB. A3a and -Vf negative way, Fig.
No license is granted by implication or otherwise under any patent or patent rights of STMicroelectronics.