AS/NZS Specifies the construction, dimension and test requirements for single-core and multi-core polymeric insulated and non-metallic sheathed. AS/NZS (R). Electric cables – Polymeric insulated – For working voltages up to and including / V. standard by. AS/NZS Category: Cord and Cables. Description: Electric cables – Polymeric insulated – For working voltages up to and including / V.
|Published (Last):||28 August 2011|
|PDF File Size:||20.2 Mb|
|ePub File Size:||2.51 Mb|
|Price:||Free* [*Free Regsitration Required]|
The measurement method described above has traditionally been carried out by manual methods and is therefore subject to human error. Cross-Linked materials are more thermally stable compared to Thermoplastic materials and will not flow when subjected to high operating temperatures.
The remaining dot points will be addressed in part 2.
It will be fairly obvious that the thickness of the insulation and sheath material must be aligned with the typical use of the product. Join the fight against non-compliant products! They may soften, but will not flow. This document defines the principles upon which electrical installations must be designed and installed in order to protect people, livestock and property from the risk of electrical shock, fire and physical injury hazards.
In terms of cables the wiring rules makes direct reference to Australian and New Zealand Standards as the principle means to ensure that its scope is fulfilled. A variety of cable insulating materials exists in the cable manufacturing industry, all having differing properties, but all having the primary attribute of being suitable as an electrical insulating material.
And neither is the diameter of a conductor important as far as compliance is concerned. This first part looks at the electrical and physical dimensional testing requirements for cables, whilst the second part looks at the range of material tests that cable materials must meet to enable compliance to be obtained. Due to the level of detail required to address this topic it will be presented in two parts.
The following sections refer to a range of tests that are conducted on cables to ensure compliance. As previously explained it is common for low voltage cable standards to define an insulation thickness which varies for different conductor sizes, with the largest conductor having the thickest insulation and sheath. Keep up to date with latest from this campaign through our Facebook page!
mzs Their differences lie in their cost, processability, dielectric nze, mechanical strength and flexibility to name a few. Some of the common cable insulating materials are listed below:. Take the online training and add your voice to this campaign!. The manner in which compliance of these materials is confirmed is complex and will be covered in some detail under the discussion later on insulating materials.
A 35mm2 copper conductor, for example, does not need to have 35mm2 of copper in it. The insulation thickness for LV cables is not primarily based on electrical requirements, but more on mechanical considerations.
The actual area is not critical nor is it a parameter that must be measured. The peak Australian electrical industry body, the National Electrical and Communications Association NECA and the world’s leading electrical industry information portal Voltimum have joined forces in an effort to raise awareness and educate users of the dangers of using product that is not compliant to Australian Standards.
To be continued in Part 2. The following briefly describes each of the above tests, their purpose and how they relate to the mechanical performance of the cable in terms of installation and long term operation of the cable.
上海南大集团有限公司 — Products — AS/NZS standard for Australia & New Zealand Market
Introduction In this article I will try to unravel some of the less known aspects of cable compliance with the overall aim to give the user the correct information to make better informed decision when selecting cable products.
PE has significantly greater dielectric strength compared to PVC, which is a blend of a number of ingredients of which Poly Vinyl Chloride is one.
This nza a very important and often misunderstood issue. These performance requirements are largely based on the mechanical properties of the materials used in cables.
Type of Business Contractor emp.
This is a legally mandated document, and therefore the risk of non-compliance is not only unsafe it is also a. Modern manufacturing techniques have seen the introduction of automated electronic measurement systems to replace manual methods that provide a significant improvement in repeat accuracy.